The Object Dialog Box is used to set the parameters of each object and the order in which the rough cut and the skims are to be machined.

• Object Name
• Object Number
• Wire Offset
• Alternate Rough Cuts
• Power Master
• Approach (object)
• Fine Hole Insert
• Wire Insert (M20)
• Rough and Skim Cuts
• Pass Number
• Cut Wire Option
• Micro Joint
• Micro Joint Width
• RA Finish
• Corner Mode (G88, G89)
• Z1, Z2, and Z5
• Taper Angle
• Land Cut
• Speed Between Objects

Sets startup EPack for Approach, Ramp On/Off and Nib Radius for present object only.

Sets Fine Hole Insert properties for present object only.

Object-Land Information allows the user to set up the land properties for the object.

The Land Power Settings Dialog Box shows settings for the present object land cut only.